Wall putty grinding mill manufacturing formula in plant pdf
Wall putty is a type of putty used to fill in cracks and holes in walls. It is typically made of a mixture of gypsum, lime, and water. The gypsum provides strength and rigidity, the lime provides adhesion, and the water helps to bind the ingredients together.
To manufacture wall putty in a plant, the following steps are typically followed:
- Mixing
The first step is to mix the gypsum, lime, and water together in a large mixer. The mixing process should be thorough to ensure that the ingredients are evenly distributed.
- Grinding
Once the ingredients are mixed, they are ground into a fine powder. This is done in a grinding mill. The grinding process helps to break down the ingredients into smaller particles, which makes the wall putty easier to spread and smooth.
- Drying
The ground wall putty is then dried. This can be done in a variety of ways, such as using a dryer or by allowing the putty to air dry. The drying process helps to remove moisture from the putty, which makes it easier to store and use.
- Packaging
Once the wall putty is dry, it is packaged for shipping. The packaging typically consists of a bag or bucket that is sealed to prevent moisture from entering.
Wall putty grinding mill manufacturing formula
The following is a typical wall putty grinding mill manufacturing formula:
- Gypsum: 70%
- Lime: 20%
- Water: 10%
This formula can be adjusted to meet the specific needs of the manufacturer. For example, the amount of gypsum can be increased to make the wall putty more strong and durable. The amount of lime can be increased to make the wall putty more adhesive. And the amount of water can be increased to make the wall putty easier to spread and smooth.
Safety precautions
When manufacturing wall putty, it is important to take the following safety precautions:
- Wear protective gear, such as safety glasses and gloves.
- Use a dust mask to avoid inhaling the dust from the grinding process.
- Be careful not to overmix the ingredients, as this can cause the wall putty to become too hard.
Wall putty grinding mills are an important part of the manufacturing process for wall putty. By following the steps outlined above, manufacturers can produce a high-quality wall putty that is safe and effective.
